Полярник, сбрасывается поворотом ключа с нажатой левой кнопкой на приборке.
Добавлено через 9 минут
98k, расшифровка сигналов приборки.
Цитата:
SYSTEM DIAGNOSIS
In the case of system trouble, check following given sequence: Step 0):Check for proper operation of warning led.
SIGNAL 1: led pulsing always carried out; pulsing time signals whether IMMO is virgin (T= 2sec) or programmed (T=0.7sec)
SIGNAL 2: always carried out. Series of pulses signalling trouble code.
0 = everything OK
1 = no serial line
2 = key or aerial failure
3 = key not valid
4 = programmed CCU and virgin IMMO
- in case of 1 pulse, check for the following;
a) proper connection of IMMO connector
b) proper connection of CCM grey body connector
c) Serial line continuity between CCN and IMMO (between pin 6 of IMMO control unit and body pin 7 of CCM)
- in case of 2 pulses, check for the following; a) proper connection of aerial connector b) possible damages to aerial cable
c) proper insertion of aerial into it’s seat
- in case of 3 pulses, check that;
a) used key has been actually stored
b) used key is not defective (key TRANSPONDER is not damaged or defective)
- in case of 4 pulses, check that;
a) keys have been properly stored (this case may occur only after replacing IMMO control unit with a brand new virgin one. Keys must be stored again)
|